How to Repair DirecTV Error 920 Issue

One of the errors that DirecTV users face is the error code 920. When you sit down to watch a show on DirecTV, you are confronted with the reality of having an error on your screen.

After thoroughly examining this particular problem, it turns out that there are extremely different potential culprits that could be responsible for this error code appearing.

What causes the DirecTV 920 error?

  • Satellite reception problem
  • Inconsistent receiver settings
  • Incorrectly tuned satellite dish

How to fix DirecTV 920 error?


Press the reset button

  1. Locate the reset button. It is red and located on the flip side of the access card.
  2. Locate the reset button. In some models, the button is located on the side of the receiver.
  3. Press the red button and wait for the receiver to reset.

Disconnect the receiver from the mains

  1. Disconnect the receiver from the power source.
  2. Then wait at least 15 seconds and plug it back in.

Restore factory settings read more

How to Repair ‘Your TV Does Not Support this Program’s Content Protection’ Issue

When using your DirecTV, you may sometimes encounter the following problem: Our TV does not support content protection for this program. You are prompted to replace your TV’s HDMI cable with a component cable to watch the program. In some situations, some people often try to turn their receivers off and on.

In this article, we will discuss all the causes of this problem and possible ways to fix it.

What causes the message “Your TV does not support content protection for this program”?

  • 1080p error
  • TV and receiver in error state
  • AT&T servers are not working
  • The connection cable is not claimed

Here’s how to fix the “Your TV does not support content protection for this program” error?


Reboot your TV

Sometimes a residual electrical charge builds up on your TV screen, which causes it to malfunction and, consequently, these errors. To remedy the situation, try discharging the HDTV completely. To do this, unplug the TV for about thirty to forty seconds and then plug it back in. Turn the TV back on, and the problem should be solved. read more