Fix BAD_SYSTEM_CONFIG_INFO 0x00000074 BSOD Error

Updated April 2024: Stop getting error messages and slow down your system with our optimization tool. Get it now at this link

1. Download and install the repair tool here.
2. Let it scan your computer.
3. The tool will then repair your computer.

BAD_SYSTEM_CONFIG_INFO Error is a kind of Windows blue screen of death error, this error begins to appear immediately after updating your Windows system to Windows 10. Not only do Windows 10 users suffer from this error, but previous versions of Windows 8.1 and 8 have also experienced this error.

This type of error can therefore occur in any version of the Windows system, this error can occur with error codes STOP 0x00000074 (0x00000003, 0x00000002, 0x80087000). This proves that BAD_SYSTEM_CONFIG_INFO can be a dangerous problem.

Incorrectly configured corrupted device drivers, driver conflicts between newly installed hardware, corrupted Windows system files or corrupted Windows registry files, hard disk errors, etc. are possible causes of the BAD_SYSTEM_CONFIG_INFO BSOD error.

 Troubleshoot & Run an Automatic Windows Repair on your PC

1. Go to the Start menu
2. Search or access the PC settings here.
3. Click on the “Troubleshooting” option.
4. After opening it, click on the “Advanced Options” button.
5. Then click on the “Automatic repair” option.
6. After troubleshooting, close the tab page
7. That’s it, it’s done.

By performing an automatic repair of your PC, you can correct this error 0x00000074 bcdedit deletevalue defect code problem numproc on your PC.

Disable Peripheral Devices

Boot your system with the necessary hardware: By booting your computer or laptop with a minimum of hardware, many system problems, including BSOD errors, can be fixed. Boot your computer with the minimum hardware required to run the operating system. If you can start your computer, it is clear that one of the remote hardware devices is causing the STOP error message.

In general, the only hardware required to boot your PC includes the motherboard, CPU, RAM, main hard disk, keyboard, graphics card and monitor.

Perform Bootrec Commands

If the initial jump does not help, you can try this method. It can help you solve problems related to poor system configuration. Once again, you must boot from the installation media and repair the computer -> Troubleshooting > Advanced Options > Command Prompt. Then execute the following commands.

bootrec /fixmbr

bootrec /fixboot

bootrec /rebuildbcd

Then restart the windows and check if there are no more blue screen errors.

Check your RAM

If the problem is not solved, remove another memory module. To identify the specific memory module that is not working properly, you may need to restart your computer more than once. For more information on adding and removing RAM from your computer, contact your computer manufacturer or refer to the documentation provided with your computer.

These are some of the most appropriate solutions to repair Bad System Config Info Blue Screen. If you have any difficulties with the repair, please leave a comment below.

https://www.dell.com/community/Desktops-General-Read-Only/Bad-System-Config-Info-stop-0x00000074/td-p/1817096


Expert Tip: This repair tool scans the repositories and replaces corrupt or missing files if none of these methods have worked. It works well in most cases where the problem is due to system corruption. This tool will also optimize your system to maximize performance. It can be downloaded by Clicking Here